btalatino.blogg.se - Iomega mhndhd network drive red light stays on

If the disk is not write protected, try another floppy disk. If you can see light, move the tab on the left side (when looking from the back) to the down position and try again.

Write Protect Error - Ensure the disk is not write protected by removing the floppy disk and verifying you cannot see through both holes. Invalid media or Track 0 Bad - Try formatting another floppy disk. If you receive any of the following errors when trying to format the floppy disk: Once at the prompt, place a diskette into the floppy disk drive and type format a. If you are running Windows 3.x, click File and select Exit Windows to get to an MS-DOS prompt. If you are running Windows 95, Windows 98, Windows ME, Windows NT, Windows 2000, or Windows 2000, click Start, Shutdown, and Restart the computer to an MS-DOS prompt. If you are not able to read or write to a floppy diskette from Windows, verify the computer is not exhibiting floppy driver issues by testing the floppy drive from MS-DOS. The above picture illustrates where each drive is connected.

If your floppy cable has more than one connection, verify it's connected to the appropriate connection.

Verify a power cable is connected to the back of the floppy drive.

If connected, disconnect and reconnect the floppy drive cable to verify it is seated properly.

Verify the floppy cable coming from the motherboard is connected to the back of the floppy drive.

If it is connected, disconnect and reconnect the cable to verify the cable is seated properly.

Verify the floppy connection is connected to the motherboard FDD connector.

Power down, unplug, and open the computer, being aware of ESD and its potential dangers.

If you have recently installed any new hardware, disconnect it temporarily to ensure that it's not causing the floppy drive not to work. Most computers need to have the floppy setup as a 3.5, 1.44 MB.Įliminating possible conflicts with other hardware If the floppy drive is not set up properly, you may experience read/write errors or the floppy may not work at all.

Verify the floppy drive is properly configured in BIOS setup. If other floppies work, you may have a bad floppy diskette. Verify that other floppy diskettes are not exhibiting the same issue. If you do not have a tab, place tape over this hole.īecause of the technology of floppy diskette drives, the floppy diskettes ist most likely bad. Verify the diskette is not write protected by sliding the tab into the opposite position, preventing light from shining through it. Verify the floppy diskette you are attempting to read from is not write protected or bad. For floppy read errors see: Why can't my computer read a floppy diskette? Bad floppy diskette The troubleshooting options and details below are for floppy disk drive issues and not for issues about not being able to read one or two floppy disks.